Draw the breakline symbol and dimension elements that contain this symbol properly
Català - Castellano - Deutsch
When doing detailed sections and other similar drawings, we tend to not draw the entire length of a facade. Rather, we detail certain parts and represent them in a sequence. To separate those different parts we use the break line symbol. This symbols also used on floor plans to represent the point where the stair intersects with the cut plane of the floor plan (at school they always told us to consider 1.5m as the cutting plane for floor plans)
AutoCAD has an express tool to draw the break line symbol, no big secret. Simply enter BREAKLINE or go to Express --> Draw --> Break-Line Symbol. You will enter the 2 points you want the break-line symbol to reach, and the third point you pick is where the jogged line will appear. See how in the detail below, 2 break line symbols have been used to separate the different parts of the detail.

If there is an element that we want to dimension that gets cut by this break line, we might want to represent the dimension symbol with a jogged line too, so whoever reads the drawing understands that the dimension shown is the real dimension not considering that we have cut part of the drawing for representation purposes. To do this, we need to use the command DIMJOGLINE, that will allow us to add the jog line to an existing dimension. The result being something like this.

1. This is cool. I have been drawing my break lines. I never knew you could just enter a command and it will do it for you.

2. Is it possible to adjust the size of the jog-line zigzag?

1. Yes, the height of the jog symbol can be changed by varying the Jog Height factor in the Lines & Arrows roll out of the Properties palette.

2. Yes, the height of the jog symbol can be changed by varying the Jog Height factor in the Lines & Arrows roll out of the Properties palette.

3. Hi L337monkeyz you can adjust the size of the jog-line zigzag. If it is in a BREAKLINE do it this way . If you want to adjust the size of the Jog of a dimension, select it and go to properties TAB and there you will find "JOG height factor" that will allow you to modify the size of the zig-zag

4. in some file it is coming but in some it is not appearing.. can u help me plz.